ESPECIAL AMÉRICA LATINA: SOLAR | LATAM SPECIAL EDITION: SOLAR PV for dynamic reactive compensation of solar inverters. Based on the above, the system operator can send instructions from the Control Centre to the photovoltaic plants to control active and reactive power. Usually, the power plant controller (PPC) will receive the operator’s instructions to control the voltage at the point of interconnection, which is generally at high voltage level. In these types of large plants, the PPC must control the many inverters that can make up the plant. This gives rise to increasingly complex control algorithms in distributed installations. Normally — at least for design-phase studies — the PPC assigns the Q Total reactive power equally among the available inverters. Our team has the latest tools for analysing and simulating the different static and dynamic plant models using power flow studies. The analysis is used to determine the minimum number of photovoltaic inverter capacity which, combined with the proper required capacitor/reactor bank, will allow the plant’s reactive power generation/absorption to meet both the static and dynamic reactive power requirements set in the network code. The capacitor bank is installed with the aim of injecting reactive power to compensate for the plant’s inherent inductive losses to the point of interconnection and to obtain the capacitive power factor required along with the ability of the photovoltaic inverters to inject reactive power. If the network operator demands an inductive power factor, this usually can be achieved da lugar a algoritmos de control cada vez más complejos en instalaciones distribuidas. Lo normal, al menos para los estudios que se realizan en la fase de diseño, es que el PPC consigne de potencia reactiva Q Total de forma idéntica entre los inversores disponibles. Nuestro equipo de trabajo posee las herramientas más actuales para el análisis y la simulación de los diferentes modelos estáticos y dinámicos de planta mediante estudios de flujos de potencia. Este análisis permite determinar el número mínimo de inversores fotovoltaicos que en combinación con el banco de condensadores adecuado necesario consigue que la generación/absorción de potencia reactiva de la planta satisfaga los requerimientos tanto dinámicos como estáticos de potencia reactiva que marca el código de red. El banco de capacitores se instala con el objetivo de inyectar potencia reactiva que compense las pérdidas inductivas inherentes de la propia planta fotovoltaica hasta el punto de interconexión y conseguir de factor de potencia capacitivo necesario junto con la capacidad de los propios inversores fotovoltaicos para inyectar potencia reactiva. Si el operador de red, demanda un factor de potencia inductivo, éste puede conseguirse únicamente con los inversores y el banco de condensadores se desconectara. En este sentido, es fundamental conocer la capacidad de potencia activa y reactiva del inversor empleado a diferentes temperaturas ambientes y niveles de tensión. En muchos casos, los inversores permiten aumentar la entrega de potencia reactiva para Imagen: Fortius Solar. 38 energética XXI · 166 · MAY17
e21_166
To see the actual publication please follow the link above